FixVault
Home › Saab › 2008 › 9-7X 4.2i › Repair and Diagnosis › Body & Frame › Fixed And MOVEABLE Windows › Repair Instructions › Windshield Replacement › Installation Procedure

Installation Procedure

  1. Install a stationary window into the opening. Refer to Adhesive Installation of Stationary Windows .
    2. Fig 1: Window Side Reveal Molding
    GM398501Courtesy of GENERAL MOTORS CORP.
  2. Install the windshield side reveal moldings.
    3. Fig 2: View Of Window Side Reveal Molding Screws
    GM398502Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  3. Install the windshield side reveal moldings screws.

    Tighten:  Tighten the windshield side reveal moldings screws to 2 N.m (18 lb in).

    4. Fig 3: View Of Front Door Sealing Weatherstrip
    GM441415Courtesy of GENERAL MOTORS CORP.
  4. Reposition the front door sealing weatherstrips (1) to the pinch-weld flange.
    5. Fig 4: Removing/Installing Weather-Strip Retainers
    GM588275Courtesy of GENERAL MOTORS CORP.
  5. Install the push-pin retainers (2) to the front door sealing weatherstrips located at the base of the windshield pillar.
  6. Install the cowl air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
  7. Install the windshield wiper arms. Refer to Windshield Wiper Arm Replacement .
  8. Install the antenna mast if equipped. Refer to Fixed Antenna Mast Replacement .
  9. Install the rearview mirror. Refer to Inside Rearview Mirror Replacement .
  10. Install the rain sensor. Refer to Windshield Outside Moisture Sensor Replacement .
  11. Close the hood.
  12. Remove the double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
About FixVault