FixVault
Home › Saab › 2008 › 9-7X 4.2i › Repair and Diagnosis › Electrical › Charging Systems › Engine Electrical › Diagnostic Information and Procedures › DTC P0622 › Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the generator.
  2. Ignition ON, engine OFF, connect a test lamp to B+ and repeatedly probe the generator field duty cycle circuit terminal 2, while monitoring the GEN-F Terminal Signal Parameter. The parameter should change from 0 percent to above 95 percent.
    • If the parameter was not affected by the test lamp, test the circuit for a short to voltage, short to ground, or an open/high resistance. If the circuit tests normal, replace the ECM.
  3. If the circuit tests normal, test or replace the generator.
About FixVault