FixVault
Home › Saab › 2009 › 9-7X 5.3i › Repair and Diagnosis › External Pages › Different variant/trim › Section 1 (Engine Controls And Fuel - 4.2L - Introduction) › Repair Instructions › Knock Sensor Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Locating Knock Sensor Components
    GM727528Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Component Fastener Tightening Caution .
  1. Install the knock sensor (1 or 2) and the bolt (3). Tighten the sensor to 25 N.m (18 lb ft).
  2. Connect the knock sensor harness connector (4).
  3. Lower the vehicle.
About FixVault