Special Conditions: Fluid

• Fluid must be completely free of bubbles and foam. In step  5, be alert to periodic bubbles that could indicate a loose connection or leaky O-ring seal in either the return hose or pressure hose.
• Discolored fluid (milky, opaque or light tan color)

Switch ignition off. Wait two minutes. Recheck hose connections. Repeat step  7- 10. If condition still exists, repeat and check for possible cause:

• Return hose clamps.
• Return hose O-ring
• Pressure hose O-rings
• Gear cylinder line O-rings

Fill system and repeat bleed procedure for each possible cause. Repeat steps  7- 10 to verify if fluid leak has been eliminated.