FixVault
Home › Saab › 2011 › 9-3X Automatic › Repair and Diagnosis › Electrical › Body Electrical › General Electrical › Repair Instructions - Control Modules › Control module, door › To fit

To fit

  1. Fit the door module pressing it obliquely upward so that the clip engages.
    Fig 1: Illustration For Steps 1-2
    G05571127Courtesy of SAAB-SCANIA OF AMERICA, INC.
  2. When changing the driver door module:  Fit the door trim screw.
  3. When changing the driver door module:  Affix the cell block with double-sided tape. The use of 16-30 20 807 is recommended.
  4. Make sure the door trim clips are in place and intact. Replace the clips if necessary.
  5. Fit the DOOR TRIM, FRONT .
  6. Cars with pinch protection:  Perform Programming of the pinch protection. See CALIBRATION OF PINCH PROTECTION .
  7. If the control module has been changed  , perform Measures after changing the control module. See Measures after changing the control module .
About FixVault