Headlamp Control Module Replacement

If the headlamp control module needs to be replaced, the following procedures must be performed:

1. Connect a scan tool to the vehicle and access SPS. Refer to SERVICE PROGRAMMING SYSTEM (SPS) 
2. Perform the SPS function Headlamp Control Module - Programming and follow the on-screen instructions.
3. Perform the SPS function Headlamp Control Module - Configuration & Setup and follow the on-screen instructions. On the screen Control Module - Configuration and Setup Function(s), select both control module Configuration/Reconfiguration and the appropriate control module Setup.
4. Clear DTCs after completing the programming procedure.