Removal & Installation (Front)

Starting at top, pull on door handle grip to disengage grip from handle. Use a small flat-blade screwdriver to disengage power door lock switch, disconnect wiring harness and remove switch. Use a small flat-blade screwdriver to gently pry tweeter speaker cover loose, and remove.
On driver's side, Use small flat-blade screwdriver to disengage power mirror switch. Disconnect switch connector and remove switch. On both sides, pull gently to remove mirror patch. Remove all door handle fasteners, and while holding inner door handle, disconnect tweeter speaker harness connector and remove door handle.
Remove lower door trim panel fasteners. Use door pad removal tool to disengage door trim side retainers. Lift up on trim panel to disengage trim panel from door, disconnect harness connectors for illumination light and remove door trim panel. Remove water deflector.
Remove lower rear window run channel by removing bolt and pulling channel down to unhook it. Run window to down position. Remove weatherstrip around front half of window. Run window halfway up. Loosen rear most regulator bolt. Remove window glass by tilting rear of glass upward and sliding up and out.
Disconnect electrical connector from regulator. Remove regulator attachment bolts. Slide regulator assembly through opening in lower center door reinforcement.
To install, reverse removal procedure.