Cylinder Block Specifications

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2001 Saturn LW200, 2001 Saturn L200, 2001 Saturn L100, 2000 Saturn LW1, and 2000 Saturn LS1. However, it is still accessible from the selected car via links, so may be relevant.

CYLINDER BLOCK ⁽¹⁾

Application

In. (mm)

Cylinder Bore

Diameter

3.385-3.386 (85.992-86.008)

Maximum Taper

.0004 (.010)

Maximum Out-Of-Round

.0004 (.010)

Maximum Piston Hight

Below Deck Surface

.035 (.90)

Maximum Deck Warpage ⁽²⁾

.010 (.254)

⁽¹⁾	For balance shaft bearing specifications, see BALANCE SHAFT & BALANCE SHAFT DRIVE table.

⁽²⁾	Cylinder block may not be machined more than .010 in. (.254). No information on maximum Deck Warpage when machining becomes necessary is available from manufacturer.