Sensing & Diagnostic Module (SDM): Installation

WARNING: This page is about a different car, the 2000 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

To install, reverse removal procedure. Connect SDM harness connector and install CPA clip. See Fig 1 . Tighten bolts to 89 INCH lbs. (10 N.m).
Activate air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEM . Check system for proper operation. See SYSTEM OPERATION CHECK .

Fig 1: Removing Sensing & Diagnostic Module (SDM)

Courtesy of GENERAL MOTORS CORP.