Lumbar Bladder: Installation
WARNING: This page is about a different car, the 2000 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Position lumbar bladder assembly into seat back. Insert tabs into seatback. Route hoses through pivot area of seat and tie strap to seat frame under seat back adjuster.
- To connect hoses, use Loctite 406, or equivalent, glue the lumbar pump/seat control module hoses to the fittings on the bladder hoses. Upper lumbar control hose from lumbar pump/seat control module will connect to new lumbar bladder hose labeled No. 3. Lower lumbar control hose from lumbar pump/seat control module will connect to new lumbar bladder hose labeled No. 4. Bolster lumbar control hose from lumbar pump/seat control module will connect to new lumbar bladder hose labeled No. 5. See Fig 1 .
- If hoses from lumbar pump/seat control module cannot be identified, reconnect seat switch and install seat, as is, into vehicle. Operate lumbar switch to identify controlled function of each hose. To complete installation, reverse removal procedure.