Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Power Steering Pump & Power Steering Pressure Hose

Courtesy of GENERAL MOTORS CORP.

Install the power steering pressure hose (2) to the vehicle.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the power steering pressure hose (2) to the power steering gear.
Tighten: Tighten the fitting to 27 N.m (20 lb ft).
Install the power steering pressure hose (2) to the power steering pump (1).
Tighten: Tighten the fitting to 27 N.m (20 lb ft).
Lower the vehicle.
Bleed the power steering system. Refer to Bleeding the Power Steering System .