FixVault
Home › Saturn › 2002 › SC2 Automatic, MP6 › Repair and Diagnosis › Body & Frame › Seats -- "S" Series › Repair Instructions › Lumbar Support Cable Replacement (SC2/SL2/SW2) › Installation Procedure

Installation Procedure

    Fig 1: Locating Seat Back Cover Hook Retainers
    GM866891Courtesy of GENERAL MOTORS CORP.
  1. Insert the lumbar actuator cable barrel into the slot located at the top center of the lumbar basket.
  2. Slide the cable through the lumbar guide.
  3. Lower the seat back cover.

    Check that the cover is centered on the seat back foam pad and frame.

  4. Push down at the hook-and-loop fastener attachment to secure the seat back cover to the pads.
  5. Check the fit of the cover and pull on the cover where necessary to remove wrinkles. Allow the free end of the actuator cable to hang loose at the outboard corner of the seat back cover and engage the interlock at the bottom of the cover.
    6. Fig 2: Lumbar Cable Routing
    GM869222Courtesy of GENERAL MOTORS CORP.
  6. Pull the cable housing away from the cable end and insert the cable barrel into the actuator slot.
  7. Route the lumbar cable assembly forward between the seat cushion and the riser bar.
  8. Align the lumbar actuator cable assembly guide with the slot in the actuator plate.
    9. Fig 3: Lumbar Actuator Cable
    GM869220Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  9. Install the lumbar actuator fasteners.

    Tighten:  Tighten the lumbar actuator fasteners to 3 N.m (27 lb in).

  10. Align the grooves on the lumbar knob with the grooves on the lumbar actuator assembly and push to install.
  11. Install the lumbar knob retaining clip.
    12. Fig 4: Headrest Lever
    GM863392Courtesy of GENERAL MOTORS CORP.
  12. Install the headrest assembly.
    13. Fig 5: Recliner Handle And Seat Adjuster Side Cover
    GM868126Courtesy of GENERAL MOTORS CORP.
  13. Install the seat in the vehicle. Refer to Front Seat Replacement - Bucket .
About FixVault