FixVault
Home › Saturn › 2002 › SL › Repair and Diagnosis › Transmission › Manual Transmission Clutches › Manual Transaxle Removal And Installation › Transaxle Disassembly/Assembly › Input Shaft Disassembly

Input Shaft Disassembly

NOTE: Synchronizer hub and sleeve must be kept together as matched set. Note spline alignment marks on hub and sleeve (indicated by the arrows).
Fig 1: Alignment Marks
G01033465Courtesy of GENERAL MOTORS CORP.
  1. Use press to disassemble input shaft. Place support under 3rd drive gear.
  2. Remove 5th gear bearing, inner-race, and thrust washer.
  3. Remove input shaft bearing.
  4. Remove 4th drive gear thrust washer.
  5. Remove 4th drive gear.
  6. Remove 4th gear blocker ring and spring.
  7. Remove 4th gear bearing.
  8. Remove 4th gear bearing race.
  9. Remove 3rd/4th synchronizer sleeve.
  10. Remove 3rd/4th synchronizer hub.
  11. Remove 3rd gear blocker ring and spring.
  12. Remove 3rd drive gear and bearing.
    Fig 2: Input Shaft Components
    G01033466Courtesy of GENERAL MOTORS CORP.
About FixVault