Removal Procedure
Courtesy of GENERAL MOTORS CORP.
- Remove the front door trim panel. Refer to Trim Panel Replacement - Side Front Door .
- Remove the front door water deflector. Refer to Water Deflector Replacement - Front Door .
- Pull back the upper weatherstrip from the rear of the window. Refer to Weatherstrip Replacement - Front Door Window .
- Remove the lower rear window run channel. Refer to Window Run Channel Replacement - Front Door .
- Remove the manual lock rod.
Courtesy of GENERAL MOTORS CORP.
- Remove the inside door handle with the actuator rod from the latch mechanism.
- Use a permanent marker to mark the lock cylinder rod to latch mechanism relationship for correct reinstallation.
- Remove the latch/lock mechanism from the door.
- Slide the lock rod off the lock cylinder arm.
- Remove the power door lock electrical connector and the 2 actuator rods from the latch mechanism.
- Remove the screws from the latch.
- Remove the latch with the lock rod from the door.
- Remove the lock rod from the latch mechanism.