FixVault
Home › Saturn › 2004 › Ion Red Line › Repair and Diagnosis › Engine Mechanical › Engine Exhaust System › Repair Instructions › Wheel Drive Shaft Heat Shield Replacement › Installation Procedure

Installation Procedure

  1. Install the wheel drive shaft heat shield into position on the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the wheel drive shaft heat shield-to-engine block bolt.

    Tighten:  Tighten the bolt to 30 N.m (22 lb ft).

  3. Install the wheel drive shaft heat shield-to-transmission mount bracket bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    4. Fig 1: View Of Wheel Drive Shaft Heat Shield
    GM878832Courtesy of GENERAL MOTORS CORP.
  4. Lower the vehicle.
About FixVault