FixVault
Home › Saturn › 2004 › Ion Red Line › Repair and Diagnosis › External Pages › Different car › Section 36 (Engine Controls - Introduction) › Repair Instructions › Barometric Pressure (BARO) Sensor Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2005 Saturn Ion Red Line. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the barometric pressure (BARO) sensor harness connector.
  2. Remove the BARO sensor bracket and bolt.
    3. Fig 1: Locating SCIP Sensor & BARO Sensor
    GM1389393Courtesy of GENERAL MOTORS CORP.
  3. Remove the BARO sensor (2).
About FixVault