FixVault
Home › Saturn › 2004 › Ion Red Line › Repair and Diagnosis › External Pages › Different car › Section 7 (Engine Mechanical) › Repair Instructions › Off-Vehicle Repair Instructions › Engine Prelubing

Engine Prelubing

WARNING: This page is about a different car, the 2004 Saturn Ion 3, 2004 Saturn Ion 2, and 2004 Saturn Ion 1. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required: 

J 45299  Engine Preluber

    IMPORTANT: A constant and continuous flow of clean engine oil is required in order to properly prime the engine. Be sure to use an approved engine oil as specified in the owners manual.
  1. Locate the oil pressure switch and remove.
    2. Fig 1: View Of Engine Oil Pressure Sensor
    GM630350Courtesy of GENERAL MOTORS CORP.
  2. Install the M12 x 1.75 adapter P/N 509376.
  3. Install the flexible hose to the adapter and open the valve.
  4. Pump the handle on the J 45299  in order to flow a minimum of 1-1.9 liters (1-2 quarts) of engine oil. Observe the flow of engine oil through the flexible hose and into the engine assembly.
    5. Fig 2: Identifying Engine Preluber J 45299
    GM863255Courtesy of GENERAL MOTORS CORP.
  5. Close the valve and remove the flexible hose and adapter from the engine.
    6. NOTE: Refer to Fastener Notice in Cautions and Notices.
  6. Install the oil pressure switch to the engine.

    Tighten:  Tighten the oil pressure switch to 22 N.m (16 lb ft).

  7. Top-off the engine oil to the proper level.
About FixVault