FixVault
Home › Saturn › 2004 › Ion Red Line › Repair and Diagnosis › External Pages › Different car › Section 7 (Engine Mechanical) › Repair Instructions › On-Vehicle Repair Instructions › Engine Mount Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Saturn Ion 3, 2004 Saturn Ion 2, and 2004 Saturn Ion 1. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place the engine mount onto the mid rail and hand start the nuts.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Tighten the engine mount to midrail nuts.

    Tighten:  Tighten the nuts to 100 N.m (74 lb ft).

    3. Fig 1: View Of Engine Mount
    GM851555Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The engine mount to intermediate bracket bolts must be hand started. Do not pry the engine mount to align the holes.
  3. Hand start the engine mount to intermediate bracket bolts.
  4. Tighten the engine mount to intermediate bracket bolts.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

    5. Fig 2: View Of Engine Mount To Intermediate Bracket Bolts
    GM851553Courtesy of GENERAL MOTORS CORP.
  5. Remove the hydraulic floor jack.
  6. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement in Engine Controls-2.2L (L61).
About FixVault