FixVault
Home › Saturn › 2004 › Ion Red Line › Repair and Diagnosis › Steering › Power Steering System › Diagnostic Information and Procedures › DTC C0545 › Test Description

Test Description

The number below refers to the step number on the diagnostic table.

  1. 2:  Tests the torque sensor in its active state.
DTC C0545

Step Action Values Yes No
Schematic Reference: Power Steering System Schematics 
Connector End View Reference: Power Steering System Connector End Views 
1 Did you perform the Power Steering Diagnostic System Check? - Go to Step 2  Go to Diagnostic System Check - Power Steering System 
2 
  1. Install a scan tool
  2. Start the engine.
  3. With the scan tool, observe the Steering Shaft Torque data parameter in the EPS Data List 2.
  4. Turn the steering wheel 90 degrees to the right and hold the steering wheel position.
Does the scan tool indicate that the Steering Shaft Torque data parameter changes state wile turning the steering wheel and is less than the specified value?		 20.70 N.m(15.2 lb ft) Go to Diagnostic Aids Go to Step 3 
3 Replace the EPS assembly. Refer to Steering Column Replacement in Steering Wheel and Column.
Did you complete the repair?		 - Go to Step 4  -
4
  1. Use the scan tool in order to clear the DTCs.
  2. Operate the vehicle within the Conditions for Running the DTC.
Does the DTC reset?		 - Go to Step 2  System OK
About FixVault