Installation Procedure

NOTE: When removing or installing the backup lamp switch, do not use an open end wrench. Use only a socket in order to avoid damage to the switch assembly.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the backup lamp switch. using pipe sealant Saturn P/N 21485278 or equivalent.
Tighten: Tighten the switch to 24 N.m (18 lb ft).
Connect the backup lamp connector.

Fig 1: View Of Backup Lamp Switch

Courtesy of GENERAL MOTORS CORP.

Install the left front wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.