FixVault
Home › Saturn › 2004 › Vue Base, 2.2 D, AWD › Repair and Diagnosis › External Pages › Different car › Section 249 (Wiper System & Washer System) › Repair Instructions › Wipers/Washer Switch Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Saturn L300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the electrical connector to the windshield wiper switch (2).
    2. Fig 1: Removing/Installing Windshield Wiper Switch Retaining Screw
    GM490097Courtesy of GENERAL MOTORS CORP.
  2. Install the windshield wiper switch (2) to the column (6).
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the retaining screw to the windshield wiper switch (2).

    Tighten:  Tighten the screw to 4 N.m (36 lb in).

  4. Install the multifunction switch. Refer to Multifunction, Turn Signal Switch Replacement in Steering Wheel and Column.
  5. Install the steering column trim covers. Refer to Steering Column Trim Covers Replacement in Steering Wheel and Column.
  6. Connect the negative battery cable.
  7. Ensure that the windshield wiper switch (2) functions properly.
About FixVault