FixVault
Home › Saturn › 2005 › Ion Red Line › Repair and Diagnosis › External Pages › Different car › Section 20 (Engine Controls (Introduction)) › Repair Instructions › Heated Oxygen Sensor Replacement - Position 2 › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Saturn Ion Red Line. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer toLifting and Jacking the Vehicle in General Information.
  2. Note the routing of the heated oxygen sensor (HO2S) electrical harness.
  3. Disconnect the HO2S electrical connector (2), in the engine compartment.
    4. Fig 1: View Of HO2S & Electrical Connector
    GM1389438Courtesy of GENERAL MOTORS CORP.
  4. Carefully bend the edge of the channel on the LH side of the exhaust heat shield outboard, just enough to release the HO2S electrical harness (1).
    5. Fig 2: Locating HO2S Electrical Harness
    GM889722Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Heated Oxygen and Oxygen Sensor Notice in Cautions and Notices.
    NOTE: Refer to Excessive Force and Oxygen Sensor Notice in Cautions and Notices.
  5. Using the J 39194  carefully remove the HO2S. See Special Tools and Equipment .
  6. Lower the HO2S electrical harness away from the underbody.
About FixVault