Installation Procedure

Connect the radio ground strap spade terminal, electrical connectors, and antenna to the rear of the radio.

Fig 1: Removing Radio
Courtesy of GENERAL MOTORS CORP.
Install the radio by sliding it into the guides on the instrument panel (I/P).

NOTE: Refer to Fastener Notice in Cautions and Notices.

Fig 2: Installing Center Trim Plate

Courtesy of GENERAL MOTORS CORP.

Install the radio fasteners.
Tighten: Tighten the fasteners to 2.5 N.m (22 lb in).
Install the center trim plate. Refer to Trim Panel Replacement - Instrument Panel (I/P) Center in Instrument Panel, Gages, and Console.