FixVault
Home › Saturn › 2005 › L300 › Repair and Diagnosis › External Pages › Different car › Section 44 (Front Suspension System) › Repair Instructions › Strut Assembly Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Saturn L300. However, it is still accessible from the selected car via links, so may be relevant.
  1. For component Installation, refer to Strut, Strut Component and/or Spring Replacement .
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 1: Removing & Installing Strut Assembly Body Attachment Nut
    GM898135Courtesy of GENERAL MOTORS CORP.
  2. Install the strut assembly to the strut tower using a new attachment nut. Tighten:  Tighten the nut to 55 N.m (40 lb ft).
    3. Fig 2: Removing & Installing Strut-To-Steering Knuckle Nuts & Bolts
    GM891540Courtesy of GENERAL MOTORS CORP.
  3. Install the strut to the steering knuckle using new strut to knuckle fasteners.
    1. Tighten: 
      1. Tighten the fasteners to 50 N.m (37 lb ft).
      2. Retighten the fasteners to 100 N.m (73 lb ft) plus an additional 30-40 degrees.
  4. Connect the stabilizer link to the strut. Refer to Stabilizer Shaft Link Replacement .
    Fig 3: Disconnecting/Connecting Stabilizer Shaft Link At Strut Assembly
    GM891609Courtesy of GENERAL MOTORS CORP.
  5. If applicable, connect the ABS harness to the brake bracket.
    6. Fig 4: View Of Brake Bracket At Steering Knuckle
    GM891828Courtesy of GENERAL MOTORS CORP.
  6. Connect the brake hose from the brake bracket.
  7. Install the tire and wheel. Refer to Tire & Wheel Removal & Installation in Tires and Wheels.
  8. Lower the vehicle.
  9. Check the wheel alignment. Refer to Measuring Wheel Alignment in Wheel Alignment.
About FixVault