FixVault
Home › Saturn › 2005 › L300 › Repair and Diagnosis › External Pages › Different car › Section 52 (Sunroof System) › Repair Instructions › Sunroof Module Assembly Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Saturn L300. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing & Installing Sunroof Module Assembly
    GM861206Courtesy of GENERAL MOTORS CORP.
  1. With an assistant, position the sunroof module into the studs located on the roof ring.
  2. Install the 2 center bolts which secure the sunroof module to the roof and tighten the bolts by hand.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the remaining sunroof module bolts. Tighten:  Tighten all of the bolts to 10 N.m (89 lb in).
    4. Fig 2: Connecting Front Drain Spout Drain Hoses On Front Sunroof
    GM893482Courtesy of GENERAL MOTORS CORP.
  4. Connect the front and rear drain hoses to the drain spouts on the sunroof module.
    5. Fig 3: Connecting Sunroof Module Electrical Connector
    GM861204Courtesy of GENERAL MOTORS CORP.
  5. Connect the electrical connectors to the sunroof motor/actuator.
  6. Secure the harness to the sunroof module.
  7. Adjust the sunroof window. Refer to Sunroof Window Height & Opening Fit Adjustment .
  8. Cycle the sunroof to verify proper operation before securing the headliner.
  9. Install the headliner. Refer to Headliner Replacement (Wagon) or Headliner Replacement (Sedan) in Interior Trim.
About FixVault