Installation Procedure

Lubricate the O-ring with clean engine oil before installation and replace the O-ring if necessary.

Fig 1: View Of CKP Sensor (7X)

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the CKP sensor bolt.
Tighten: Tighten the bolt to 11 N.m (97 lb in).
Connect the CKP sensor electrical connector.
Connect the block heater electrical connector, if equipped.
Connect the catalytic converter. Refer to Exhaust Seal Replacement in Engine Exhaust.
Lower the vehicle.
Perform the CKP system variation learn procedure. Refer to CKP System Variation Learn Procedure .