FixVault
Home › Saturn › 2005 › Relay AWD › Repair and Diagnosis › External Pages › Different car › Section 103 (Engine Controls - 3.4L - Introduction) › Repair Instructions › Accelerator Controls Cable Bracket Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Pontiac Aztek and 2005 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Accelerator Bracket & Cable
    GM260171Courtesy of GENERAL MOTORS CORP.
  1. Position the accelerator cable bracket on the throttle body.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the nut (3) and bolts (1, 2).

    Tighten: 

    • Tighten the bolts in sequence (2, 1) to 13 N.m (115 lb in).
    • Tighten the nut in sequence (3) to 10 N.m (89 lb in).

    3. Fig 2: Locating Accelerator Controls Cable
    GM12831Courtesy of GENERAL MOTORS CORP.
  3. Connect the cruise control cable into accelerator cable bracket.
  4. Connect the accelerator cable to the throttle body lever.
  5. Connect the cruise control cable to the throttle lever and accelerator bracket, if applicable.
About FixVault