Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac Montana SV6, 2007 Chevrolet Uplander, and 2007 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Instrument Panel (I/P) Accessory Trim Plate

Courtesy of GENERAL MOTORS CORP.

Connect the HVAC control module electrical connectors.
Install the HVAC control module into the I/P opening.

NOTE: Refer to Fastener Notice .

Install the HVAC control module bolts/screws.
Tighten: Tighten the bolts/screws to 2.5 N.m (22 lb in).
Install the I/P accessory trim plate.
Re-calibrate the actuators. Refer to Actuators Recalibration .
Refer to Control Module References for programming and setup information.