FixVault
Home › Saturn › 2005 › Relay AWD › Repair and Diagnosis › External Pages › Different car › Section 18 (Supplemental Inflatable Restraint System) › Repair Instructions › SIR Disabling and Enabling Zone 1 › Disabling Procedure

Disabling Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the steering wheel so that the vehicles wheels are pointing straight ahead.
  2. Place the ignition switch to the OFF position.
  3. Remove the key from the ignition switch.
  4. Locate the body control module (BCM) fuse center then remove fuse center cover.
    5. Fig 1: Locating AIR BAG (IGN) And AIR BAG (BATT) Fuses In Fuse Center
    GM1316302Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: This inflatable restraint sensing and diagnostic module (SDM) has two fused power inputs. To ensure there is no unwanted SIR deployment, personal injury, or unnecessary SIR system repairs, remove both AIR BAG (IGN) and AIR BAG (BATT) fuses from the BCM fuse center. With the AIR BAG fuses removed and the ignition switch in the ON position, the AIR BAG warning indicator illuminates. This is normal operation, and does not indicate an SIR system malfunction.
  5. Locate and remove the AIR BAG (IGN) and AIR BAG (BATT) fuses from the BCM fuse center.
    6. Fig 2: Locating Front End Sensor
    GM1316303Courtesy of GENERAL MOTORS CORP.
  6. Open front hood and locate the front end sensor (1), also known as the electronic front sensor (EFS).
  7. Remove both connector position assurance (CPA) from the right and left front end sensor connector.
  8. Remove both front end sensors connector from the front end sensor (1).
About FixVault