FixVault
Home › Saturn › 2005 › Relay AWD › Repair and Diagnosis › External Pages › Different car › Section 18 (Supplemental Inflatable Restraint System) › Repair Instructions › SIR Disabling and Enabling Zone 1 › Enabling Procedure

Enabling Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the key from the ignition switch.
    2. Fig 1: Locating Front End Sensor
    GM1316303Courtesy of GENERAL MOTORS CORP.
  2. Connect both front end sensors connector to the front end sensor (1).
  3. Connect both CPA's to each front end sensor connector.
    4. Fig 2: Locating AIR BAG (IGN) And AIR BAG (BATT) Fuses In Fuse Center
    GM1316302Courtesy of GENERAL MOTORS CORP.
  4. Install the AIR BAG (IGN) and AIR BAG (BATT) fuses into the BCM fuse center (1).
  5. Use caution while reaching in and turn the ignition switch to the ON position.

    The AIR BAG indicator will flash then turn OFF.

  6. Perform the Diagnostic System Check - Vehicle if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System Check - Vehicle in Vehicle DTC Information.
About FixVault