FixVault
Home › Saturn › 2005 › Relay AWD › Repair and Diagnosis › External Pages › Different car › Section 18 (Supplemental Inflatable Restraint System) › Repair Instructions › SIR Disabling and Enabling Zone 2 › Enabling Procedure

Enabling Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the key from the ignition switch.
  2. To enable the SIS-Left go to step 3. To enable the roof rail module-left go to step 7, and to enable the seat belt pretensioner-LF go to step 9.
    3. Fig 1: Identifying Side Impact Sensor (SIS) Connector
    GM834331Courtesy of GENERAL MOTORS CORP.
  3. Install the SIS-Left connector (4) to the SIS (2).
  4. Install the CPA (3) to the SIS-Left connector (4).
    5. Fig 2: View Of Door Trim Panel And mounting Screws
    GM804355Courtesy of GENERAL MOTORS CORP.
  5. Install the LH door trim panel (2). Refer to Trim Panel Replacement - Side Front Door in Doors.
    6. Fig 3: Locating Roof Rail Module Connector
    GM899820Courtesy of GENERAL MOTORS CORP.
  6. Connect the roof rail module-left connector to the vehicle harness connector.
  7. Install the CPA to the roof rail module-left connector.
  8. Install the garnish molding to the upper lock pillar. Refer to Garnish Molding Replacement - Rear Corner Upper in Interior Trim.
    9. Fig 4: View Of Seat Belt Pretensioner Connector And Wiring Harness Routing
    GM899818Courtesy of GENERAL MOTORS CORP.
  9. Connect the seat belt pretensioner-LF and install the CPA.
  10. Install the lower center pillar. Refer to Garnish Molding Replacement - Center Pillar Lower in Interior Trim.
    11. Fig 5: Locating AIR BAG (IGN) And AIR BAG (BATT) Fuses In Fuse Center
    GM1316302Courtesy of GENERAL MOTORS CORP.
  11. Install the AIR BAG (IGN) and AIR BAG (BATT) fuses into the BCM fuse center.
  12. Install the BCM fuse center cover.
  13. Use caution while reaching in and turn the ignition switch to the ON position.

    The AIR BAG indicator will flash then turn OFF.

  14. Perform the Diagnostic System Check - Vehicle if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System Check - Vehicle in Vehicle DTC Information.
About FixVault