Enabling Procedure
WARNING: This page is about a different car, the 2005 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the key from the ignition switch.
- Connect the vehicle harness yellow connector (2) to the LF side impact module yellow connector (1).
- Install the CPA (3) to the LF side impact module yellow connector (1).
- Install the AIR BAG (IGN) and AIR BAG (BATT) fuses into the body control module fuse center (1).
- Use caution while reaching in and turn the ignition switch to the ON position.
The AIR BAG indicator will flash then turn OFF.
- Perform the Diagnostic System Check - Vehicle if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System Check - Vehicle in Vehicle DTC Information.
Fig 1: Disconnecting/Reconnecting Vehicle Harness Yellow Connector To/From Side Impact Module Yellow Connector