FixVault

Enabling Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the key from the ignition switch.
  2. Fig 1: Disconnecting/Reconnecting Vehicle Harness Yellow Connector To/From Passenger Side Impact Module Yellow Connector
    GM854381Courtesy of GENERAL MOTORS CORP.
  3. Connect the vehicle harness yellow connector (2) to the RF side impact module yellow connector (3).
  4. Install the CPA (1) to the RF side impact module yellow connector (3).
  5. Fig 2: Locating AIR BAG (IGN) And AIR BAG (BATT) Fuses In Fuse Center
    GM1316302Courtesy of GENERAL MOTORS CORP.
  6. Install the AIR BAG (IGN) and AIR BAG (BATT) fuses into the body control module fuse center (1).
  7. Use caution while reaching in and turn the ignition switch to the ON position.

    The AIR BAG indicator will flash then turn OFF.

  8. Perform the Diagnostic System Check - Vehicle if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System Check - Vehicle in Vehicle DTC Information.