FixVault
Home › Saturn › 2005 › Relay AWD › Repair and Diagnosis › External Pages › Different car › Section 191 (Wiper System & Washer System) › Repair Instructions › Wiper Motor Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac Montana SV6, 2007 Chevrolet Uplander, and 2007 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Wiper Motor Crank Arm
    GM1527648Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: A new wiper motor will be shipped in the parked position.
  1. Position the crank arm (5) to the wiper motor pivot shaft. Ensure the arm resides between the 2 casting dimples (2) as shown.
    2. NOTE: Refer to Fastener Notice .
  2. Install the crank arm pivot nut (4).

    Tighten:  Tighten the pivot nut to 10 N.m (89 lb in).

  3. Using the J 39529  , secure the transmission link (1) to the wiper crank arm (5). See Special Tools .
    4. Fig 2: Positioning Wiper Module Assembly
    GM1527641Courtesy of GENERAL MOTORS CORP.
  4. Position the module assembly to the lower plenum. Refer to Wiper Motor Module Replacement .
    5. Fig 3: Disconnecting/Reconnecting Wiper Motor Connector
    GM1501847Courtesy of GENERAL MOTORS CORP.
  5. Connect the electrical connector (2) to the wiper motor (1).
  6. Reposition the wiper arms.
  7. Inspect the front wiper system operation.
About FixVault