Installation Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Disconnecting Accelerator Pedal Position Sensor Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Install the accelerator assembly (2) to the vehicle.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the accelerator mounting bolts (1) to the accelerator bracket.
Tighten: Tighten the accelerator pedal nuts to 10 N.m (89 lb in).
Connect the accelerator pedal position sensor electrical connector.
Confirm that the accelerator sensor connector locking clip is fully secured.
Verify the operation of the accelerator pedal.