Installation Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing Blower Motor Resistor

Courtesy of GENERAL MOTORS CORP.

Install the blower motor control processor.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Tighten the blower motor control processor screws.
Tighten: Tighten the blower motor resistor screws to 1.5 N.m (13 lb in).
Install the blower motor control processor wire harness connector.
Install the right closeout panel. Refer to Closeout/Insulator Panel Replacement - Right in Instrument Panel, Gages and Console.