FixVault
Home › Saturn › 2005 › Relay AWD › Repair and Diagnosis › External Pages › Different car › Section 26 (Body Rear End) › Repair Instructions › Liftgate Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Liftgate
    GM1315506Courtesy of GENERAL MOTORS CORP.
  1. With the aid of an assistant, align marks on liftgate with liftgate hinges.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. With the aid of an assistant, install the liftgate hinge bolts.

    Tighten:  Tighten the hinge bolts to 25 N.m (18 lb ft).

  3. Install the liftgate struts. Refer to Strut Replacement - Liftgate .
  4. Remove the protective coverings.
  5. Install the liftgate wiring harness.
  6. Install the liftgate trim panels.
  7. Remove the support and close the liftgate.
About FixVault