FixVault
Home › Saturn › 2005 › Relay AWD › Repair and Diagnosis › External Pages › Different car › Section 31 (Theft Deterrent System) › Repair Instructions › Theft Deterrent Control Module Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Theft Deterrent Control Module
    GM1207719Courtesy of GENERAL MOTORS CORP.
  1. Install the theft deterrent control module.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Tighten the theft deterrent control module screws.

    Tighten:  Tighten the screws to 5 N.m (44 lb in).

  3. Install the ignition switch. Refer to Ignition Switch Replacement in Instrument Panel, Gages and Console.
  4. Perform the vehicle theft deterrent system learn procedure. Refer to Programming Theft Deterrent System Components .
About FixVault