FixVault
Home › Saturn › 2005 › Relay AWD › Repair and Diagnosis › External Pages › Different car › Section 33 (Body Front End) › Repair Instructions › Hood Latch Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Hood Release Cable
    GM863872Courtesy of GENERAL MOTORS CORP.
  1. Install the hood latch release cable to the hood latch.
  2. Position the hood latch to the alignment marks on the support bracket.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the hood latch bolts.
  4. Tighten the latch bolts with the latch in the full up position.
  5. Slowly close the hood and press down until the hood is flush with the fenders.
  6. Open the hood.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  7. Adjust the hood, if required. Refer to Hood Adjustment .
  8. Install the fascia support.
  9. Close the hood.
About FixVault