FixVault
Home › Saturn › 2005 › Relay AWD › Repair and Diagnosis › External Pages › Different car › Section 40 (Front Suspension System) › Repair Instructions › Steering Knuckle Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Strut-To-Steering Knuckle Nuts & Bolts
    GM866391Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the steering knuckle to the strut assembly and if applicable the ABS harness bracket.

    Tighten:  Tighten the bolts and nuts to 120 N.m (89 lb ft).

  2. Guide the axle through the steering knuckle.
    3. Fig 2: View Of Tie Rod End To Steering Knuckle
    GM854972Courtesy of GENERAL MOTORS CORP.
  3. Install the lower control arm. Refer to Lower Control Arm Replacement .
  4. Install the outer tie rod to the steering knuckle.

    Tighten: 

    1. Tighten the nut to 20 N.m (15 lb ft).
    2. Turn the nut an additional 180 degrees.
    3. Verify the torque to 50 N.m (37 lb ft).

  5. Install the wheel bearing, brake rotor, brake caliper and front wheels. Refer to Wheel Bearing/Hub Replacement - Front .
  6. Lower the vehicle.
  7. Road test the vehicle in order to verify alignment. If a lead or pull is present refer to Measuring Wheel Alignment in Wheel Alignment.
About FixVault