FixVault
Home › Saturn › 2005 › Relay AWD › Repair and Diagnosis › External Pages › Different car › Section 40 (Front Suspension System) › Repair Instructions › Wheel Stud Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Washers & Wheel Nut - 5-Stud Pattern
    GM1233071Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the NEW stud into the bearing/hub assembly.

    Add enough washers (1) in order to draw the stud into the hub.

  2. Install and tighten a wheel nut (2) until the head of the wheel stud is fully seated against the back of the bearing hub flange.
  3. Remove the wheel nut (2) and the washers (1).
  4. Install the brake rotor, and install the brake caliper and bracket as an assembly. Refer to Brake Rotor Replacement - Front in Disc Brakes.
  5. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  6. Lower the vehicle.
About FixVault