FixVault
Home › Saturn › 2005 › Relay AWD › Repair and Diagnosis › External Pages › Different car › Section 54 (Sunroof System) › Repair Instructions › Sunroof Water Gutter Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing Water Gutter From Track Assembly
    GM1224100Courtesy of GENERAL MOTORS CORP.
  1. Position the sunroof water gutter to the sunroof window track assembly.
  2. Pull downward on the front edge of the water gutter to allow standing bosses to clear the cross-member. Seat the tabs on the water gutter into the slots in the track assembly, and push the water gutter forward until the tabs lock into place.
  3. Ensure that all 6 tabs are secured.
    4. Fig 2: Removing 3 Screws That Secure Water Gutter
    GM1224097Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the water gutter screws.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

    5. Fig 3: Removing Sunroof Module From Vehicle
    GM1222469Courtesy of GENERAL MOTORS CORP.
  5. Install the sunroof module assembly. Refer Sunroof Module Assembly Replacement .
  6. Remove the masking tape from the roof panel.
About FixVault