FixVault
Home › Saturn › 2005 › Relay AWD › Repair and Diagnosis › Steering › Power Steering System › Repair Instructions › Power Steering Gear Heat Shield Replacement › Installation Procedure

Installation Procedure

    Fig 1: View Of Right Side Engine Splash Shield
    GM629009Courtesy of GENERAL MOTORS CORP.
  1. Install the steering gear heat shield.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the steering gear heat shield bolts.

    Tighten:  Tighten the steering gear heat shield bolts to 14 N.m (124 lb in).

  3. If the vehicle is equipped with all wheel drive, install the right side engine splash shield. Refer to Splash Shield Replacement - Engine in Body Front End.
  4. Lower the vehicle.
About FixVault