Installation Procedure

WARNING: This page is about a different car, the 2005 Pontiac Aztek and 2005 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Rear Fender Liner Rear Stud Nut

Courtesy of GENERAL MOTORS CORP.

Position the fender liner to the fender, over the studs and behind the rocker molding.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the nut to the stud at the rear of the front fender liner.
Tighten: Tighten the front fender liner rear nut to 10 N.m (89 lb in).

Fig 2: Locating Front Fender Liner Rear Stud Nut

Courtesy of GENERAL MOTORS CORP.

Install the nut to the stud at the front of the front fender liner.
Tighten: Tighten the front fender liner front nut to 10 N.m (89 lb in).

Fig 3: View Of Front Fender Liner Retaining Screws

Courtesy of GENERAL MOTORS CORP.

Install the screws to the front fender liner at the front bumper fascia and fender.
Tighten: Tighten the front bumper fascia and fender screws to 2 N.m (18 lb in).