FixVault
Home › Saturn › 2005 › Relay FWD › Repair and Diagnosis › External Pages › Different car › Section 106 (Body Front End) › Repair Instructions › Hood Latch Support Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Pontiac Aztek and 2005 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Hood Latch Support Bracket
    GM624214Courtesy of GENERAL MOTORS CORP.
  1. Install the hood latch support bracket to the upper radiator tie bar.
    2. Fig 2: Identifying Hood Latch Support Bracket Mounting Bolts
    GM624216Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the four bolts to the hood latch support bracket.

    Tighten:  Tighten the hood latch support bracket bolts to 25 N.m (18 lb ft).

    3. Fig 3: Aligning Hood Latch Release Cable
    GM624217Courtesy of GENERAL MOTORS CORP.
  3. Reposition the hood latch release cable to the hood latch support bracket.
  4. Install the hood latch to the hood latch support bracket. Refer to Hood Latch Replacement .
  5. Adjust the hood, if required. Refer to Hood Adjustment .
  6. Connect the electrical harness to the hood latch support bracket.
  7. Close the hood.
About FixVault