FixVault
Home › Saturn › 2005 › Vue Red Line, FWD › Repair and Diagnosis › Transmission › Automatic Trans › Automatic Transmission - 5AT - Introduction & Repair Instructions › Repair Instructions › Output Speed Sensor Replacement › Installation Procedure

Installation Procedure

    Fig 1: Input/Output Speed Sensor, Bolt & Screw
    GM1230002Courtesy of GENERAL MOTORS CORP.
  1. Apply automatic transmission fluid to the new output speed sensor O-ring seal.
  2. Install the new output speed sensor O-ring seal onto the output speed sensor.
  3. Install the output speed sensor into the transmission case assembly.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the output speed sensor bolt.

    Tighten:  Tighten the bolt to 12 N.m (106 lb. in.).

  5. Connect the wiring harness to the output speed sensor.
  6. Lower the vehicle.
About FixVault