FixVault
Home › Saturn › 2005 › Vue Red Line, FWD › Repair and Diagnosis › Transmission › Automatic Trans › Automatic Transmission - 5AT - Introduction & Repair Instructions › Repair Instructions › Shift Control Replacement › Removal Procedure

Removal Procedure

    IMPORTANT: All shifter cable and park lock cable clips are one time usage only. Any service repair requiring cables to be disconnected from the transaxle control cable bracket or shiftier assembly will require a cable clip replacement.
  1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 8 in SIR.
  2. Remove the console. Refer to Console Replacement in Instrument Panel, Gages, and Console.
    3. Fig 1: Removing/Installing Shifter Cable From Control Assembly
    GM944208Courtesy of GENERAL MOTORS CORP.
  3. Using the J 36346  , disconnect the shifter cable from the control assembly pin.
  4. Remove the shifter cable retainer clip and remove the cable from the control assembly. Discard the clip.
    5. Fig 2: Disconnecting/Connecting Park Lock Cable Assembly From Pin On Control Assembly
    GM944348Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the park lock cable assembly from the pin on the control assembly.
  6. Depress the tab on the park lock cable and remove the cable from the control assembly. Discard the park lock cable clip.
    7. Fig 3: Removing/Installing Indicator Bulb By Rotating Bulb A Quarter Turn And Pulling Out
    GM945404Courtesy of GENERAL MOTORS CORP.
  7. Remove the indicator bulb by rotating the bulb a 1/4 turn and pulling out.
    8. Fig 4: Disconnecting/Connecting Control Assembly Electrical Connectors
    GM944353Courtesy of GENERAL MOTORS CORP.
  8. Disconnect the control assembly electrical connectors.
    9. Fig 5: Removing/Installing Nuts From Control Assembly
    GM944361Courtesy of GENERAL MOTORS CORP.
  9. Remove the nuts from the control assembly.
  10. Remove the control assembly and replace if necessary.
About FixVault