FixVault
Home › Saturn › 2006 › Ion Red Line › Repair and Diagnosis › Engine Performance › System › Engine Controls - Introduction (2 Of 2) › Repair Instructions › Fuel Pressure Gage Installation and Removal › Removal Procedure

Removal Procedure

  1. Ensure the fuel pump is OFF.
    Fig 1: SA9127E Or J 34730-1A & Fuel Pressure Service Port
    GM1387198Courtesy of GENERAL MOTORS CORP.
  2. Place the bleed hose of the SA9127E  , or the J 34730-1A  into an approved fuel container. See Special Tools .
  3. Open the bleed valve on the SA9127E  , or the J 34730-1A  in order to bleed the fuel system pressure. See Special Tools .
  4. Place a shop towel under the fuel pressure service connection to catch any remaining fuel spillage.
  5. Remove the SA9127E  , or the J 34730-1A  from the fuel pressure service connection. See Special Tools .
  6. Drain any fuel remaining in the SA9127E  , or the J 34730-1A  into an approved fuel container. See Special Tools .
  7. Inspect for leaks using the following procedure:
    1. Turn the ignition ON, with the engine OFF for 2 seconds.
    2. Turn the ignition OFF for 10 seconds.
    3. Turn the ignition ON, with the engine OFF for 2 seconds.
    4. Turn the ignition OFF.
    5. Inspect for leaks.
  8. Install the cap on the fuel pressure service connection.
About FixVault