FixVault
Home › Saturn › 2006 › Ion Red Line › Repair and Diagnosis › Engine Performance › System › Engine Controls - Introduction (2 Of 2) › Repair Instructions › Manifold Absolute Pressure (MAP) Sensor Replacement (SCIP) › Removal Procedure

Removal Procedure

Fig 1: Locating SCIP Sensor & BARO Sensor
GM1389393Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the supercharger inlet pressure (SCIP) sensor harness connector.
  2. Remove the SCIP sensor (1) from the supercharger.
    IMPORTANT: If the SCIP sensor seal is damaged, the SCIP sensor must be replaced.
  3. Inspect the seal for damage.
About FixVault