FixVault
Home › Saturn › 2006 › Ion Red Line › Repair and Diagnosis › External Pages › Different car › Section 99 (Engine Controls - Introduction) › Repair Instructions › Air Cleaner Outlet Resonator Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Saturn Ion 3, 2005 Saturn Ion 2, and 2005 Saturn Ion 1. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the air outlet resonator to the throttle body.
  2. Connect the fresh air duct to the air outlet resonator.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Tighten the air outlet resonator to throttle body clamp.

    Tighten:  Tighten the clamp to 5 N.m (44 lb in).

    4. Fig 1: View Of Air Cleaner Outlet Resonator
    GM851256Courtesy of GENERAL MOTORS CORP.
  4. Align the air outlet resonator to the bracket and install the push-pin fastener.
  5. Connect the air cleaner assembly fresh air duct to the air outlet resonator.

    Tighten:  Tighten the clamp to 5 N.m (44 lb in).

    6. Fig 2: View Of IAT Sensor Harness Connector
    GM851290Courtesy of GENERAL MOTORS CORP.
  6. Connect the IAT sensor harness connector.
About FixVault